I get no action on the level meters except for a heap of noise showing on the input tab which I can't hear either through the computer or the MBox2. See attached alsamixer pic: 'This sound device does not have any controls' for the MBox2, although it does show controls under Pulseaudio V Control under the heading 'Integrated Rate Matching Hub Analogue Stereo'. There's a lot more besides about the other devices. This is just the section concerning the MBox2. Hardware device with all software conversions From 'aplay -L':Ĥ.0 Surround output to Front and Rear speakersĤ.1 Surround output to Front, Rear and Subwoofer speakersĥ.0 Surround output to Front, Center and Rear speakersĥ.1 Surround output to Front, Center, Rear and Subwoofer speakersħ.1 Surround output to Front, Center, Side, Rear and Woofer speakersĭirect hardware device without any conversions Tried a few months later and nothing, same error as this. The odd thing is that I installed the 13.04 kernel in 12.04 sometime ago (the drivers for the MBox are in that kernel but not 12.04) and it worked perfectly. Doesn't crash the computer (as it did in earlier releases), but is just not operational with Audacity. The Mbox is sitting there with its green light on and looking quite happy. There are other issues with Audacity in 14.04, but I'll start here. When I choose the Mbox in Audacity and attempt to record I get the attached screenshot error. usbcore: registered new interface driver snd-usb-audio usb-audio: Digidesign Mbox 2: 24bit 48kHz usb-audio: device not ready, resending boot sequence. usb-audio: Sending Digidesign Mbox 2 boot sequence. I plug in the Mbox and dmesg gives me the read out: Using 14.04 minimal install with xfce4, Audacity 2.0.5 and this kernel:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |